DJI Mavic Pro camera shield
DJI Mavic Pro camera shield
3D
Published 2017-01-23T10:29:05+00:00
This is a shield for the camera on the DJI Mavic Pro drone, it is mostly designed for reducing sun glare while taking pictures/video but can also help with wind causing shaking in the gimbal and also can protect the camera/gimbal assembly in a small crash by dampening the hit the camera would normally take.
Unlike other shields I have seen this one will allow the camera to be tilted up at least partially without interfering.
It does require a small amount of support below the rear connector tab. It may also require a small support around the bottom of the rounded gimbal cover as well as the top of the camera cutout depending on your printer. on my FlashForge Creator pro I only needed the supports under the rear connector tab when printed at a .18mm layer height.
| 发表的日期 | 23/01/2017 |
| 让时间去下载 | - 72 分钟 |
| 材料数量 | 8.5 grams |
| 尺寸大小 | 58mm x 52mm x 41mm |
| 打印工艺 | FDM |
| 复杂程度 | pages.object.complexitymedium |