Woman nude body optimised for vase mode
Woman nude body optimised for vase mode
3D
Published 2019-02-01T17:00:50+00:00
Highly optimised version to be printed easily and faster in vase mode!
Recommended settings with 0.4 mm nozzle:
CURA: Special Modes -> Spiralize Outer Contour
S3D: Layer -> Single outline (Vase Mode)
Slic3r/Prusa Slicer: Print setting -> Spiral vase
NO SUPPORT!
PS: Keep in mind that the most important factor to have better overhangs is the ratio between line width and layer height, LW / LH >= 5
If the model has problems, decrease the printing speed and increase the cooling if possible.
PRINT SETTINGS
50% size ( 30 minute):
Layer height: = 0.10 - 0.11 mm
Line width/Extrusion Width: 0.55*
Speed: 20 mm/sec Wall
Minimum layer time: 3s
Temperature: +5C
Fan: 100%**
100% size (90 minute):
Layer height: 0.12 - 0.13 mm
Line width/Extrusion Width: 0.65*
Speed: 25 mm/sec Wall
Minimum layer time: 6s
Temperature: +10 C°
Fan: 75%**
200% size (230 minute):
Layer height: 0.16 - 0.17 mm
Line width/Extrusion Width: 0.8*
Speed: 30 mm/sec Wall
Minimum layer time: 10s
Temperature: +15 C°
Fan: 75%**
*Yes, it is possible to change the width of the line, up to 0.8 mm even with a nozzle from 0.4 mm
**Only for PLA and for better interlayer adhesion, but if the overhang are wrong, increased to 100 as well. (PETG 100%, ABS 25%)
Optimisations:
- Head cut at a greater angle for better overhang
- Slightly lower shoulders for better overhang
- Reduced pit above the clavicle
- Adding venetian dimples
- Most proportioned body
- Increased definition between the legs and the buttocks
- Fixed the hole between legs
| 发表的日期 | 01/02/2019 |
| 让时间去下载 | 30 - 200 分钟 |
| 支持自定义 | YES |
Sublime ColorFab XT-CF20 carbone 0.2mm layer