Mine Now Mimic Dice Guardian - SUPPORT FREE!
$3.99 Mine Now Mimic Dice Guardian - SUPPORT FREE!
3D
Published 2025-03-11T19:59:19+00:00
By downloading this item, you agree:
- Not to distribute the files
- Not to sell prints of this item.
You ARE permitted to print this item as a gift. Only Merchants with an active License may print & Sell FatesEnd items.
🔗MMF: bit.ly/FatesEndTribe
🔗PATREON: bit.ly/FatesEndPatreon
While you're at it, check out Furhaven: bit.ly/FurhavenGame
════════════════════════════════════
🗝️👁️ Mine Now Mimic Dice Guardian 👁️🗝️
Some treasures are best left untouched! The Mine Now Mimic Dice Guardian is the perfect protector for your prized dice, lurking with a mischievous grin and ready to snatch up anything that comes too close. This support-free, 3D-printable STL captures the classic mimic in all its deceptive glory—part treasure chest, part hungry monster!
✨ Features:
- Support-free design for effortless 3D printing
- Sized to hold standard 20mm D20 dice
- Highly detailed sculpt, bringing this sneaky shapeshifter to life
- Perfect for RPG lovers, dice goblins, and mimic enthusiasts alike!
Keep your dice safe… or let the Mimic decide what’s truly yours! 🎲💀
════════════════════════════════════
EASY TO PRINT! Our files are designed to be 3D Printed easily without supports! (Supports are the WORST!) Due to the nature of miniatures, our miniatures & ornaments are pre-supported if needed!
Most FatesEnd files are designed to fit on a 7"x7"x7" print bed area or larger! All dice towers are designed to work with standard 20mm dice at 100% scale. (Dice set/tower scales are determined by the size of the D20 in the set.) If you need to scale the files, you may use the Dice Scale Chart found here: fatesend.net/resources
Our models are designed to be support-free for easy FDM printing—no supports needed!
- Layer Height: 0.2mm for standard prints, 0.12mm for finer details (enable Z-hop for delicate prints)
- Wall Loops: 3-4 for strength and durability
- Infill: 6-8% using gyroid pattern for optimal strength and efficiency
- Supports: Not needed! Our models are crafted for hassle-free printing
- Bed Adhesion: A well-leveled bed is usually enough, but a brim can help for extra stability
If you run into any issues or need advice, feel free to reach out! We love seeing your prints—share them with us using #FatesEnd!
| Date published | 11/03/2025 |
| Price | $3.99 |
| Menge an Filament | 62,657 mm³ (or 62.66 mL) |
| Dimensionen | 46.96mm x 71.04mm x 54.05mm |
| Technologie | FDM |
| Support Free | YES |
Today I learned that most of my dice are not - in fact - "standard" size. They always rolled just fine in the dice towers, but they don't quite fit here at 100%. I busted out the calipers and discovered they are 23mm-24mm each. So I'm going to print another at 120% just in case. Still, love this design!