Baby Dragon Book Box
$4.99 Baby Dragon Book Box
Published 2026-04-13T18:05:49+00:00
*This item requires 5x2mm magnets
By downloading this item, you agree:
Not to distribute the files
Not to sell prints of this item.
You ARE permitted to print this item as a gift. Only Merchants with an active License may print & Sell FatesEnd items.
🔗MMF: bit.ly/FatesEndTribe
🔗PATREON: bit.ly/FatesEndPatreon
While you're at it, check out Furhaven: bit.ly/FurhavenGame
════════════════════════════════════
📖 Baby Dragon Book Box
Support-Free | Hidden Storage | Display Piece
This charming book box features a curled baby dragon nestled protectively across a trio of ornate books, blending cozy fantasy with clever functionality. Beneath the detailed covers lies a hidden storage compartment.
Perfect for stashing dice, trinkets, or small treasures you’d rather keep tucked away from prying eyes.
PEGS: You can use these pegs instead of magnets (free file): https://www.myminifactory.com/object/peg-alternative
OR any 5mm x 2mm cylinder magnet will do.
Features:
- This item requires 5x2mm magnets
- Support-free and optimized for FDM printing
- Hidden storage compartment inside the book stack
- Perfect for dice, small items, or decorative display
🐉 A peaceful little guardian… watching over your hoard.
════════════════════════════════════
EASY TO PRINT! Our files are designed to be 3D Printed easily without supports! (Supports are the WORST!) Due to the nature of miniatures, our miniatures & ornaments are pre-supported if needed!
Most FatesEnd files are designed to fit on a 7"x7"x7" print bed area or larger! All dice towers are designed to work with standard 20mm dice at 100% scale. (Dice set/tower scales are determined by the size of the D20 in the set.) If you need to scale the files, you may use the Dice Scale Chart found here: fatesend.net/resources
*This item requires MAGNETS/PEGS: You can use these pegs instead of magnets (free file): https://www.myminifactory.com/object/peg-alternative
OR any 5mm x 2mm cylinder magnet will do.
Our models are designed to be support-free for easy FDM printing—no supports needed!
- Layer Height: 0.2mm for standard prints, 0.12mm for finer details (enable Z-hop for delicate prints)
- Wall Loops: 3-4 for strength and durability
- Infill: 6-8% using gyroid pattern for optimal strength and efficiency
- Supports: Not needed! Our models are crafted for hassle-free printing
- Bed Adhesion: A well-leveled bed is usually enough, but a brim can help for extra stability
If you run into any issues or need advice, feel free to reach out! We love seeing your prints—share them with us using #FatesEnd!
| Date published | 13/04/2026 |
| Precio | $4.99 |
| Sin apoyo | YES |