Printed using the presupported file and used anycubic standard grey resin.

Printed in PLA on prusa mini. Supports were tricky but came off easily enough. Really great model.

Brother & Sister

Printed on Elegoo Mars 2 Pro with Ceramic Gray Water Washable resin. Scaled to 200%, hollowed, supported, and sliced with Lychee slicer.

This is an amazing model!

I adore this print, and was so fun paining it. I so hope you will make more baby versions.

Such a fun model, thank you!

Resin prints made as keyrings for my friends

Wonderful

Small one is original size, large one is scaled 360%

I'm a little late to the party. This little guy was my first 3D print and my first paint job ever. Thank you so much for this incredibly cute model!...

Really really cute little model. nice for beginners at painting. Thank you for sharing.

printed on my sparkmaker in resin

Printed on an Ender 3 V3 SE at 150%. Even though it was already supports I had to add support and a brim to keep the pre supports connected to the bed during print. Nice model. My wife likes it.

first resin print

I loved this model so much, i had to put it in a diorama. Tried to make it look like it was in a children's play room, but copying Eeyores house on the hill from the films.

Christmas Present

Printed fine and nicely detailed. I printed it for a friends kid's 1st Birthday. One note however: Best to use some ABS-Like Resin. I used standard and it was so brittle I snapped the tail off the first 2. so I printed 5, to tails broke off releasing from supports. Finally finished one completely, just to have the tail snap off gluing it to the base. So be very careful with it and use a more flexible Resin or filament.