LightSpeed is a ready to 3d print marble machine that utilizes a unique magnetic launching system unlike anything else.

This marble machine is powered by a magnetic launching mechanism. It works similar to a gaussian launcher and a newton's cradle. Watch the following videos to see how it works:

How it works: https://youtu.be/vxfALiptGJ0
Setup: https://youtu.be/fc6bEeK_9pM

--- Includes ---
Ready to print STL files.
No Supports Needed (results may vary)

Disclaimer:

Printing results may vary. Slight model imperfections are present in gear and final track. Base is a difficult print but is definitely possible.

Have sand paper and hot glue gun ready for worst case scenarios. 

--- Hardware List ---
Magnet: https://www.apexmagnets.com/other/1-2-x-1-2-x-1-8-block-magnets-adhesive-backed-neodymium-magnets
DC Motors: https://amzn.to/3pMaxyQ​
Metal Rods: 3mm x 25mm

Power Adapters: https://amzn.to/2P5ZkfQ​
DC Switch: https://amzn.to/3umNfDf​
USB Cable: https://amzn.to/2OXwpdE​
Wire: https://amzn.to/3bxF2DB​
Shrink-wrap: https://amzn.to/3khNB9q​
Soldering Iron: https://amzn.to/37E5s59

--- Setup Instructions ---
https://youtu.be/QF-1IH4628k