Minimalist Wallet
Minimalist Wallet
3D
Published 2019-05-17T08:55:23+00:00
A minimalist wallet design that has an adjustable thickness based on your selection of o-ring. If you only typically carry a couple credit cards, or if you carry a fat wad of cards and cash, this can likely accomodate your needs! Just find 5 of the appropriate sized o-rings to fit your desired thickness and you're good to go!
You can find a great selection of o-rings at Amazon or a local hardware store. In the wallet pictured I used size P16 (15.8 x 2.4 mm) nitrile o-rings. It holds about 9 cards and a couple bills snug!
--------------------------THANK YOU!----------------------------
This item is offered free, but a lil' tip is always appreciated!
This item prints in 2 parts with no supports needed. There is only one body in this file download, just duplicate it to create both halves. PLEASE MAKE SURE to print with the o-ring tab extrusions pointing upward. They extrude beyond the primary flat face of the wallet 1.25mm. If they were pointed downward, it would cause a bad droop in your print.
| Date published | 17/05/2019 |
| Dimensiones | 92mm x 58 mm x 3.5 mm |
| Sin apoyo | YES |