Temple of Ra Dice Tower - SUPPORT FREE!
$6.99 Temple of Ra Dice Tower - SUPPORT FREE!
3D
Published 2021-09-09T08:44:05+00:00
From FatesEnd2 Kickstarter: wwww.FatesEndTowers.com
**Check out my newest Kickstarter campaign, Furhaven! A family friendly 5e compatible RPG! (3D Printables available too!) >> http://kck.st/33FAsmD
Temple of Ra Dice Tower!
I created this dice tower for my Kickstarter campaign: Fates End 2: Terra & Cosmos! This dice tower is designed to work with typical 16mm (based on D6) dice sets. The D20 in that set is 20mm. If you want to print this tower smaller, you can print it at 60% for tiny 10mm dice sets.
*Non-commercial License. Please don’t sell prints of this file, you’re welcome to give them away as gifts though.
*Only Merchants are permitted to sell prints of these files. If interested, please check the MERCHANT LISENCE section of the Kickstarter campaign.
No Supports! Print at 100% for rolling regular-sized dice sets. (16mm based on the D6.)
| Date published | 09/09/2021 |
| Precio | $6.99 |
| Sin apoyo | YES |
Printed it in white marble PLA as I don't have sandstone marble. It looks very nice like that, but uses a LOT of material, so this is easily the most expensive print I have done so far. Decided to print the top in silk gold PLA in memory of the Khufu pyramid which (mythically) used to have a gold top stone (in reality it was most likely basalt). Gonna use this dice tower to play the upcoming Mythic Battles expansion set in Mythological Egypt!