TIE FIGHTER
Sin soporte
Destacado
39,038
visitas
8,179
descargas
141
colecciones
51 comentarios
Cargando comentarios... 
TIE FIGHTER
3D
Published 2020-04-13T23:20:43+00:00
1329
51
Add to Collection
Descripción
It is very important to print the different pieces in the provided orientation to prevent undesirable fillings. No glue needed. No additional support is needed. Clean carefully the brim and supporting parts before assembling the model. You can follow the instructions sheet for print and assembly.
Take care, this model needs a 3d printer with at least 210 mm. of build volume.
This model has been sliced using Cura 4.0 and printed in a Ultimaker 2.
Have fun!
Información técnica
| Date published | 13/04/2020 |
| Sin apoyo | YES |
Más información
Archivos
Hi. I just finished mine! Do you know if it is possible to place your Darth Vader as the pilot of this design? I'll post the photos of my print ... I had a lot of work on the wings ... because I needed the internal panels to be printed in black, like the original, so I divided the wings into 4 parts. Congratulations on another amazing job! May the force be with you!