Brush Bud | Painting Accessory
.JPG)
.JPG)
.JPG)
.JPG)
.JPG)
.JPG)
.JPG)
.JPG)
$2.99 Brush Bud | Painting Accessory
3D
Published 2025-11-15T15:39:27+00:00
Hey Miniature Makers!
This week, we made a fun little desk accessory you might actually find useful!
Sometimes I’ve got a lot going on in my painting space, and clear areas disappear fast. I usually wash my brush, then lay it on the edge of my water pot or on a bit of paper towel, but that’s how brushes get crushed, bent, or roll away on me 😂
That’s where the Brush Buddy comes in! It’s small (55 × 64 mm), so it doesn’t take up much space, but it can hold up to three brushes vertically to keep them out of the way, and one can rest across the open mouth. The tapered holes fit anything from thin detail brushes to chunky base-coaters.
Already have a brush holder? Just scale it up or down and use it as a fun piece of scatter terrain!
INCLUDES:
Brush Bud
As always, they come laid flat for FDM and fully pre-supported for Resin printing!
| Date de publication | 15/11/2025 |
| Price | $2.99 |