Alternative OpenLOCK Clip (more flexible)
Alternative OpenLOCK Clip (more flexible)
3D
Published 2019-02-06T12:05:26+00:00
OpenLOCK is an awsome connection system for dungeon tiles. My only problem with it was how stiff the clips were, which sometimes made them hard to remove by hand. So I made this more flexible version, which I personally like a lot. See printing details for questions on material choice.
The OpenLOCK system is developed by @Printable Scenery.
General: When in doubt if a material works, print a test clip and see if the flexing is right for you and if it might break under load
FDM: The clips were designed to be printed on FDM printers with a 0.4 mm nozzle and should work in any material, my PLA worked fine but some types of PLA might be too brittle.
Resin: The clips can be printed in non-brittle resin (Tough / ABS-like / ...). Standard resin will most likely be too brittle.
| Date published | 06/02/2019 |
| Support Free | YES |
Printed with cheapest resin, with no supports. Works like a charm.