Note that I have included .STL files, GCODE files, and .X3G files as well. So not only will you have the raw data, but can use the EXACT settings I used to print mine. I have also included a .IGES of the whole thing put together, just incase you need some more instruction on what goes where. Battery hatch: - Print lying flat, without support or raft, this will ensure the snap feature works - 0.20mm, 10% infill, 22 min print time, 4g filament Lower Housing: - Doesn't need raft or support, though it may warp without raft - 0.20mm, 10% infill, 5 hour 11 min print time, 63g filament Upper Housing: - Needs support - 0.20mm, 10% infill, 6 hours 46 min print time, 86g filament. Both of the textured pads: - need support - 0.20mm 10% infill, 20 min print time, 4g filament (each)