Loading
Medieval Fantasy Wizard Tower
3D
Published 2023-01-23T09:40:00+00:00
$5.00 Medieval Fantasy Wizard Tower
3D
Published 2023-01-23T09:40:00+00:00
🧙♂️ Medieval Fantasy – Wizard Tower STL | 3D Printable Terrain | Multi-Floor Fantasy Building
Bring arcane mystery to your tabletop world with this high-detail Wizard Tower, a multi-level structure perfect for mages, scholars, and magical encounters. Designed with rich fantasy architecture, interior play space, stairways, and decorative columns, this tower makes an impressive centerpiece for RPGs and wargames.
✅ Included in the Pack:
9 STL files total
3 tower floors
Roof section
Stair sets
Small & large column sets
Detailed fantasy doors
Super detailed structure with carved stone and fantasy motifs
Easy to 3D print
Fully tested on resin and FDM printers
🎯 Perfect For:
Dungeons & Dragons
Pathfinder
Frostgrave
Age of Sigmar
3D dioramas & display builds
Fantasy tabletop wargames
RPG adventures needing a mystical tower
🖨️ Printing Tips:
Most pieces print without supports, depending on your setup. Floors and roof sections print best flat on the build plate for clean alignment and crisp detail.
🛒 Visit Our Shop:
Explore matching fantasy buildings, miniatures, props, and terrain packs to expand your tabletop worlds!
Measurements (1st Floor – Wizard Tower):
Length: 148.7 mm (5.85 in)
Width: 124.77 mm (4.91 in)
Height: 114.36 mm (4.50 in)
Measurements (Roof – Wizard Tower):
Length: 174.9 mm (6.89 in)
Width: 153.93 mm (6.06 in)
Height: 124.72 mm (4.91 in)
*All measurements are approximately.*
wizard tower stl, fantasy tower, mage tower terrain, dnd terrain, rpg tower, tabletop scenery, fantasy building stl, medieval tower, diorama terrain, 3d printable fantasy, fdm terrain, resin stl, wizard building
To ensure the best results with your STL file, follow these tips:
Orientation: Position the miniature on its base or flat side to reduce supports and maintain detail.
Supports: Use minimal supports where necessary to preserve fine details and avoid warping.
Layer Height: For optimal detail, set your layer height to 0.1mm or 0.2mm.
Infill Density: A 10-20% infill density usually provides a good balance between strength and material use.
Temperature: Follow the recommended temperature settings for your filament to avoid issues with adhesion or detail loss.
Adhesion: Ensure proper bed adhesion to prevent shifting or warping during printing.
Feel free to reach out if you have any questions or need additional support. Happy printing!
| Date published | 23/01/2023 |
| Price | $5.00 |
| Dimensions | 41cm tall |
| Support Free | YES |
