Simple 16mm Dice // Single and Dual Color
Simple 16mm Dice // Single and Dual Color
3D
Published 2018-12-20T11:51:01+00:00
Part of my Folding Polyhedra Pack! These dice print unfolded so they can be more balanced (although it's certainly not perfect yet). This also leads to nice surface finish and allows for using the multiple pass printing technique for multicolor with a single extruder. There's also a single color version. Though you can do a filament swap after the first couple of layers for the dots to be a second color.
Print. Snap into place, starting with the loop of four sides, then the remaining two opposite sides.
I found these to hold together really well printed with MatterHackers PRO PLA on my Anycubic i3 Mega, but it's not a bad idea to use a drop or two of cyanoacrylate (super glue) to be absolutely sure it doesn't come apart.
05.12.20 Update - added blank version
| Date published | 20/12/2018 |
| Support Free | YES |
@MakeAnything @Leea: I find this a little weird. I'm using Cura4.4.1. If I used Center Selected Models, all the dots are not aligned with body according to preview and actual print. It's OK if I used Merged Models option in preview mode. Besides that I have another problem which is it prints the contour of body while printing the dots on the first layer as you can see in the picture. Is there any print order besides "one at a time"? Cura doesn't like one on top the other when slicing with this option turned on.