Stryga-Pattern Gunship
$15.00 Stryga-Pattern Gunship
3D
Published 2023-07-10T09:00:30+00:00
Fully pre-supported!
The Stryga-Pattern Gunship is one of the most versatile multi-role aircraft found in the galaxy's imperial regiments. Capable of being retrofitted on the fly by sanctioned Tech-Priests to fly under almost any atmospheric conditions, the Stryga finds itself a prized commodity in the higher echelons of command as their personal transport aircraft.
While rarer than its more common cousin, it fulfills the role of air-to-ground strikes and troop transport with a much more aggressive payload and versatility. Capable of being outfitted with missiles, rocket pods, lascannons, bolters, and gatling rotary cannons, it can be equipped for any mission and any target, where in mass troop landings or impressive, earthshattering gun runs.
Features:
-4 different cockpit styles based on grimdark versions of popular gunships and helicopters.
- Variety of wing and rotor options, some of which are not mutually exclusive.
-To solve the structural integrity of rotor blades printed in resin, the rotor mast is designed with the inclusion of 2mm brass rods that are to be treaded through the mast and the rotors. These can be easily found on Amazon.
- Fully magnetized weapon hardpoints on the wings.
- Simple, easy to print push-to-fit design.
- Matches size of similar aircraft in wargames as a proxy.
-Pieces are all sliced in components that make it easily printable and supportable while being able to hide support scarring in the seam lines.
-Fully Pre-Supported. Make sure your exposure and settings are dialed into prevent failures or support scarring.
-Approximately 10% larger than the intended proxy in default configuration. Dimensions different depending on wing layout, but comes with a flyer mount connection point on the underside of the hull for the original size base.
Update V1: Added in free Vulture Gunship gatling cannons.
Update V2: Added in a separated top hull piece for smaller printers. Comes with two engines and the center top hull plate. Currently not presupported just yet.
Update V3: MMF made some changes to the uploads file structure, so old folders were a mess. Reuploaded with proper setting and should be clean to use now.
If you print this, please post it! I love to see people make my prints!
Reddit: MaelstromDesignworks
Insta: @MaelstromDesignworks
See Necrotech Printing for physical models!
https://www.necrotechprints.com/
Test Printed on a Mono X 6k with auto-supports in Chitubox using Siraya Tech Fast ABS-Like Navy Gray
1.8s exposure
0.02mm layer height
10 bottom layers at 22s exposure
60mm/s lift speed
Angled to approximately 45 degrees
| Date published | 10/07/2023 |
| Price | $15.00 |
done ... in a week or so ..