A 3D printed model rocket launch pad built to last! With an adjustable leg for leveling and/or aiming your rocket into the wind. Designed for use with standard 1/8" or 3/16" (Maxi) sized rod for fun with ALL sized rockets. The Main leg needs printed 2x and only 1x of the other pieces for a complete launch pad.

Very little hardware will be required to finish this launch pad.*

BOM-
A)1x- 1/8"  x 24" rod
B)1x- 3/16" x 48" rod (optional)
C)1x- 1/4" Keyless Chuck
D)2x- 1/4-20 x 1" bolt (hex or allen cap)
E)1x- 1/4" ID nylon washer
F)1x- 1/4-20 nylon insert lock-nut
G)1x- 3mm x 0.5mm x 20mm bolt (hex or allen cap)
H)1x- 1/2" OD toothed lock-washer (min. 3mm ID)
I)1x- 1/2" OD fender washer (min. 3mm ID)
J)1x- 3mm x 0.5mm wing-nut
K)1x- large tin can lid (coffee cans size ideal)
L)3x- 1/4-20 x 3 1/2" bolt (hex or allen cap) (optional)**
M)3x- 1/4-20 nylon insert lock-nut (optional)**
N)3x- 1/4" ID split-lock washer (optional)**
O)3x- 1/4" ID flat washer (optional)**

**Note- Optional hardware for bolting launch pad together, otherwise the launch pad snaps together and may be glued for permanent installation.